• D-A-WH-小キャップ部品有
  • D-001-wh1-rgb
  • D-001-wh2-rgb

001 Tension Rod A / 002 Tension Rod B / White

Vertical / Horizontal tension rod whose length is adjustable from 75 to 115 cm (from 30 to 45 inch) or from 115 to 190 cm (from 45 to 74.8 inch). With shelf or hanger attached, you could use this tension rod at a variety of life scenes. The tension rod can be placed without making damage on the walls and easy to relocate so that you can use this tension rod flexibly. The tension rod can be fixed by the simple-designed screw lock method. White color which can be coordinated anywhere.

*Indoor Use only.
*Please check the installation width.
*The steal is mat finished to create the distinct texture. when pointed tip touch the steal, the surface could be damaged.

001 Tension Rod A (Horizontal/Vertical) White 75~115cm (30~45 inch)

002 Tension Rod B (Horizontal/Vertical) White 115~190cm(45~74.8 inch)

SPEC
Pole: Steel / Epoxy Powder Coating
Resin Portion: ABS / EVA
Screw: Brass / Steel / ABS
Stapler Needle: Stainless

Attachment: Manual Description, Stapler Needle (1 bunch), Screw (8 sets)

HOW TO USE

【Horizontal Installation】

1.Check that the contact surface is suitable.

2.Turn the Rotary Knob to the direction of “LOCK” to check whether the Rotary Knob can work and then turn the Rotary Knob back to the direction of “FREE” until the edge of the Rotary Knob is on the position of “START” line. *In case the Rotary Knob is turned back too much over the “START” line, it would be the cause of the damage of this product.

3.Entwist the Brass Screw into the nut on the Main Body by around 1 turn. *In case the entwisting is too much, the Inner Pipe cannot be pulled out or get flawed.

4.Draw out the Inner Pipe to the full distance between the contact surfaces and tighten the Brass Screw into the pipes tightly so that the length can be fixed by the penetration into the Inner Pipe.

5.Turn the Rotary Knob to the direction of “LOCK” by 1~3 turns as a tentative fix.

6.Adjust the round cap positions on both ends to set the rod vertical to the installation surfaces.

7.Further, by checking that the installation surfaces cannot be damaged, turn the Rotary Knob to the direction of “LOCK” to fix this product by tension force.

8.Check that this product is firmly and correctly installed before using this product.

[NOTE]
In case the Rotary Knob exceed the “LIMIT” line, the installation method might be wrong or the installation contact surfaces might not be correct. Please check the strength of the installation contact surfaces again and start from the initial step to install.

 

* As for the product specification, the recommendable condition, installation method or other notices, please check the manual instruction or check the manual by downloading from this page's link. 

 


 

【Vertical Installation】

Installation Method is same as “Horizontal Installation”

* As for the product specification, the recommendable condition, installation method or other notices, please check the manual instruction or check the manual by downloading from this page's link.